Medema Mini Crosser M1 Manuel d'utilisateur télécharger pdf (Page 10)

Quick guide P9-0155-Q

10 of 16

Version 2.0.3/2013

Medema Production A/S

Battery indicator

If there is an electronic fault, a number of lamps in the battery indicator will

light up. The following table shows what they mean.

For further information on troubleshooting see the User Manual.

Lamps Causes Remedy

1 lamp The batteries need charging

or the connection to a battery

is poor.

Check all connections

between the controller and

batteries. If these are ﬁ ne, try

charging the batteries

2 lamps Poor connection to the motor. Check the connection

between the motor and

controller. Contact supplier.

3 lamps Short-circuit between

the motor and a battery

connection.

Contact supplier - say how

many lamps are lit.

4 lamps Not in use

5 lamps Not in use

6 lamps The S180 is prevented

from driving. Inhibit 2 is

active. This may be due to

the battery charger being

connected, the plug to the

thermal switches being

disconnected, a fault in the

thermal switch or the scooter

is overheating.

The Mini Crosser will turn

itself off automatically after

it has been stationary for 10

minutes. The battery indicator

ﬂ ashes with 6 lamps at a rate

of about 3 seconds.

Stop the unit and wait 3-5

minutes before restarting.

Turn the key to 0 and then to

1 to reset the fault.

Contact supplier.

To start M1 again, the key

must be turned to position 0

and back to I.

7 lamps Accelerator fault. Make sure that the

accelerator is in neutral when

the Mini Crosser is turned on.

8 lamps Controller fault. Contact supplier.

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 16

Commentaires sur ces manuels

Pas de commentaire

Medema Mini Crosser M1 Manuel d'utilisateur Page 10

Commentaires sur ces manuels

Produits connexes et manuels pour Scooters Medema Mini Crosser M1