Medema Mini Crosser M-MaxX Manuel d'utilisateur télécharger pdf (Page 41)

User guide P9-0135-B 41 of 52 Version 1.0.3/2012

Medema Production A/S

Troubleshooting

The following is a list of various problems that, in our

experience, may occur. The list gives possible causes and

remedies.

Problem Possible causes Remedy

The Mini Crosser will not

go.

The battery indicator is

not lit.

The key has not been

turned to start.

The batteries are

completely ﬂ at.

The control fuse has blown.

The main fuses have blown.

Turn the key and wait 5

sec. before activating the

accelerator.

Charge the batteries.

Change the fuse.

Contact supplier.

The Mini Crosser will

not go, but the battery

indicator is lit.

The Mini Crosser has

been overloaded.

There is a fault in the

electronics.

The batteries are ﬂ at.

The charging plug has not

been removed.

Wait approx. 1 min. before

trying again. The vehicle

must be turned off (see

section on Fuses).

Contact supplier.

Remove the charging

plug.

The driving speed is too

low.

The speed selector is on

slow.

The electronics are

overloaded.

There is too little air in the

tyres.

Change to a faster speed.

Stop and wait a few

seconds before starting.

Pump the tyres up to the

right pressure.

The driving distance per

charge is too short.

There is a problem with

the batteries.

Low temperature.

There is a problem with

the charger.

There is too little air in the

tyres.

The charging method is

wrong.

Charge the batteries and

check that the green lamp

on the charger lights up

before driving off.

Contact supplier.

Pump the tyres up to the

right pressure.

Read the section on

Charging in the User

Manual.

The charging lamp on

the charger does not light

up when the charger is

connected to the mains

and the Mini Crosser.

No power to the switch.

Fault in cable.

Fault in charger.

Turn the switch on.

Contact supplier.

Read the operating

instructions for the

charger.

Contact supplier.

The “ready” lamp on the

charger does not light up

even though the charger

has been on for 10-12

hours.

There has been a power

cut.

The charger is doing a

top-up charge.

There is a problem with

the batteries.

There is a fault in the

charging plug for the Mini

Crosser M-MaxX.

Reconnect the charger

and repeat the charging

process.

Check again half an hour

later.

Contact supplier.

Push the charging plug all

the way in and repeat the

charging process. Read

the operating instructions

for the charger.

1 2 ... 36 37 38 39 40 41 42 43 44 45 46 ... 51 52

Commentaires sur ces manuels

Pas de commentaire

Medema Mini Crosser M-MaxX Manuel d'utilisateur Page 41

Commentaires sur ces manuels

Produits connexes et manuels pour Scooters Medema Mini Crosser M-MaxX